How do I correctly position the cable on the PX-2010NT's cutter to ensure accurate and safe cutting?

During the installation and maintenance of cables, accurate cutting is an important part of ensuring the quality and safety of cable connections. For users of the PX-2010NT crimping tool, correctly placing the cable on the cutter is not only related to the accuracy of cutting, but also directly affects work efficiency and operational safety. The following is a detailed guide on how to correctly place the cable on the PX-2010NT crimping tool.

Ⅰ. Preparation
Before starting cable cutting, users should ensure that the PX-2010NT crimping tool is properly connected to the power supply and is in a stable working state. At the same time, check whether the blade of the cutter is sharp. If it is found to be worn or damaged, it should be replaced in time to ensure the cutting effect.

Ⅱ. Cable selection and measurement
Choose the appropriate cable type and specification according to actual needs. Use a tape measure or measuring tool to accurately measure the length of the cable to be cut, and mark the cable for subsequent operations.

Ⅲ. Cable placement
1. Cable positioning: Place one end of the cable on the cutter of the PX-2010NT crimping tool, ensuring that the axis of the cable is perpendicular to the blade of the cutter. This helps to ensure the straightness and accuracy of the cutting.
2. Fix the cable: After the cable is in place, use the clamp or pressure plate on the PX-2010NT crimping tool to gently fix the cable to prevent it from moving or sliding during the cutting process.
3. Adjust the cutting depth: According to the diameter and material of the cable, adjust the blade depth of the cutter appropriately. Generally speaking, the blade depth should be slightly greater than the diameter of the cable to ensure the thoroughness of the cutting.

IV. Cutting operation
After confirming that the cable is correctly placed and fixed, the user can press the cutting button on the PX-2010NT crimping tool to start the cutting operation. During the cutting process, the user should keep his hands away from the cutting area to avoid accidents.

V. Check after cutting
After the cutting is completed, the user should carefully check whether the cut of the cable is flat and burr-free, and check whether the end face of the cable is neat. If any problems are found, they should be repaired or adjusted in time with the included tools.

Through the above steps, the user can correctly place the cable on the cutter of the PX-2010NT crimping tool and ensure that the cutting is done.